The PLC Tools SIM-ALD Current Loop Simulator Dual Channel simulates two independent 2-wire loop powered transmitter channels.

For each channel five fixed output settings are available: 4 mA, 8 mA, 12 mA, 16 mA or 20 mA.

A specific output selection is made by connecting signal wire to one of the five output terminals.

It is not recommended to connect more than one output at the same time. If this happened, maximum current limited to 24mA per channel.

Simulator can work with wide range of loads from 0 to 1000 Ohm, typical analog input impedance is 250 Ohm. Loads above 500 Ohm require 24V or higher loop power supply. A typical 2-wire installation requires a loop power supply usually provided by an external 24VDC power supply.

Some sourcing analog input modules can provide loop power also. Follow the analog input module specification for a power supply selection.

Typical Two-Wire Simulator Connection with an External Loop Power Supply

Typical Two-Wire Simulator Connection with a Sourcing Analog Input

Important:
Do not use this device for calibration of input modules or instruments. This device is a simple tester that provides current signal within a selected range.

Do Not Operate Device Unless Area Is Non-Hazardous

Specifications:

  • Device Simulation. Two-Wire Loop Powered Devices

  • Power Supply. 12-30V DC 24VDC typical

  • Current Output

    • Number of Channels: 2 Isolated
      Output Range: 4mA to 20mA
      Fixed Preset: 4 , 8, 12, 16, 20 mA
      Output Selection:       Terminal
      Output Accuracy:       ±1% of full scale( 0.2mA)at 25°C

  • Protection: Reverse Polarity

  • Load Range: 0-1000 Ohm 250 Ohm typical

Loads over 500 Ohm require 24V or higher power supply

Currently the device does not carry any agency approvals and is not compliant with RoHS.

Disclaimer

This device is intended to provide general assistance with current loop debugging, testing and application development.

It should not be permanently used in live production systems.

Accordingly, production system must be tested and commissioned with real instruments to ensure safe and reliable operation.

IN NO EVENT SHALL THE DEVICE MANUFACTURER BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT, INDIRECT, INCIDENTAL,CONSEQUENTIAL, LOSS OF PROFIT OR DAMAGE.

The examples and diagrams in this manual are included for illustrative purposes only. Because of the many variables and requirements associated with any particular installation, the device manufacturer cannot assume responsibility or liability for actual use based on the examples and diagrams.

Before making any decision or taking any action that might affect your equipment, you should consult a qualified professional advisor.